26
Check that all the safety switches are functioning
Bed lower limit switch
Bed safety switch
Bed upper limit
switch
1.
Lower the bed until it hits the lower limit switch. The bed travel must
stop once the switch is activated.
2.
With the sanding belt and the drive belt running, activate the bed
safety switch. The sanding belt and the drive belt must stop once the
safety switch has been activated.
3.
Raise the bed until it hits the bed upper limit switch. The bed travel
must stop once the switch is activated.
4.
With the sanding belt and the drive belt running, press the
emergency stop button. The machine must stop.
5.
With the sanding belt running, press the sanding belt stop button.
The sanding belt must stop.
6.
With the drive belt running, press the drive belt stop button. The
drive belt must stop.
Sanding.
Sanding is a finishing process, and no more than 0.008" should
be removed with each pass. Larger cuts will result in jamming, poor
surface finish, burn marks, excessive sandpaper wear, excessive motor loading, and so on.
Wearing the correct safety equipment, start sanding as follows.
1.
Switch on the dust collector.
2.
Set the bed to a height that will just miss the thickest part of the job.
3.
Raise the table with each pass until the job is sanded over the complete surface.
5
6
Emergency stop
Summary of Contents for MSANWB25X60-1K-7.5-0197
