33
Problem
Possible cause
Solution
Display fails to come on.
Breaker tripped.
Reset breaker.
Power switched off.
Switch power on.
Display faulty.
Replace display.
Display shows incorrect
figures.
Incorrect figures input
into computer.
Input correct figures.
Computer corrupted.
Turn power off then on.
Display faulty.
Replace display.
Sanding belt clogs.
Sanding grit too fine.
Change the belt to a
coarser grit.
Depth of cut too big.
Reduce depth of cut.
Oil or dirt on sanding
surface.
Clean wood or discard.
Poor dust collection.
Check for dust collection
blockage.
Sanding belt slows down
during a cut.
Feeding the wood too
fast.
Slow down the feed rate.
Dull sanding belt.
Replace the sanding belt.
Low voltage.
Check the incoming
voltage to the machine.
Excessive depth of cut.
Reduce depth of cut.
Glazed sanding belt.
Stock is wet.
Dry the stock or replace
stock with dry stock.
High resin content of
stock.
Replace stock with low-
resin stock.
Grit comes off the
sanding belt easily.
Poor quality sanding belt. Replace sanding belt with
good-quality sanding belt.
Sanding belt stored in an
incorrect environment
(damp).
Discard belt.
Sanding belt creased or
folded.
Discard sanding belt.
Sanding belt breaks.
Belt assembled to
machine with arrows in
the wrong direction.
Replace belt.
Troubleshooting
Summary of Contents for MSANWB25X60-1K-7.5-0197
