3. ASSEMBLY & SETUP
15
II.
DADO FITTING
1.
Disconnect the power source.
NOTE: Serious personal injury could occur if you connect your machine to the
power source before you change blade.
2.
Move the blade tilt to 0
H
and raise the saw blade as high as it can be adjusted.
3.
Push the saw guard up and loosen the fixed
bolts of insert. Take off the insert
plate.(Fig.3-5.1 & 3-5.2)
4.
Open the red cover, R (Fig. 3-5.2a).
Note: the red cover is used as a guard for protecting operators from injured by
the blades
5.
Insert the T-wrench to hole
A
(Fig. 3-5.3) to fix the main saw spindle. Then use
wrench to loose the nut and washer then fit the 1
st
blade (Fig. 3-5.5)
6.
Fit iron plate. (Fig 3-5.6)
7.
Fit the 2
nd
blade. (Fig 3-5.7)
8.
Tight the screw and washer on then close the red blade guard cover.
9.
Place the table insert for Dado as Fig. 3-5.8
to finish the fitting process.
Fig. 3-5.5
Fig. 3-5.6
Fig. 3-5.7
Fig. 3-5.8
Summary of Contents for MTST5S-0135
