3. INSTALLATION
12
3-4. FITTING THE CROSSCUT FRAME & EXTENSION FENCE ASSEMBLY
I.
Fitting the crosscut frame
1.
Fit the crosscut frame by putting
A
(Fig. 3-4.1) into the end of swing arm
B
(Fig.
3-4.1). At the same time, fit frame
C
(Fig. 3-4.1) by insert fix plate
F
(Fig.3-3.1c) of
the crosscut frame to groove
D
(Fig. 3-4.1) of the sliding table
.
Note: the fix plate F has to be placed as Fig. 3-4.1c
2.
Make sure
A
(Fig. 3-4.1) is placed properly in the swing arm
B
(Fig. 3-4.1).
3.
Tighten lever
E
(Fig. 3-4.1)
※
Notice: To move or take off the crosscut frame, withdraw
lever
E
(Fig. 3-4.1)
II.
Fitting the crosscut fence
1.
Fit the T-nut R (Fig. 3-4.1a) into crosscut frame holes G (Fig. 3-4.1) then slide the
square support pipe in (see arrow of Fig. 3-4.1b).
2.
Fit square pipe
I
(Fig. 3-4.2) to R
(Fig. 3-4.1a) of crosscut frame. And tighten knob
J
(Fig. 3-4.1b & 3-4.2) for fixing on crosscut frame.
All fitting operations in this section require approx. 2 people
Figure 3-4.1
E
C
G
A
D
B
J
Figure 3-4.1b
Figure 3-4.1a
R
wider
Figure 3-4.1c
F
The hole has to be closer
to the top edge
Summary of Contents for P12 10
