4. OPERATION
33
II. POSITION OF FENCE PLATE
1.
Vertical position
(Fig. 4-5.4a) turn to the work piece
2.
Horizontal position (Fig. 4-5.4b) for cutting thin work piece and for slanting cuts.
It will be safer to move the work piece forwards by using pusher.
3.
Tighten the handle
F
(Fig. 4-5.2).
※
Steps to take the rip fence unit out :
1.
Loosen lever
A
(Fig. 4-5.2)
2.
Loosen knob
B
(Fig. 4-5.2)
3.
Lift the whole rip fence unit and turn it
90° counter clockwise.
(Fig. 4-5.5a&b)
4.
Lightly move rip fence unit out from the round bar by passing through the metal
locker.
NOTE:
For the execution of special working, the operators are obliged to put his
hands near the tools. However, based on safety reasons, they could use a
proper pusher to move the work piece forwards, push it against the fence or
to move it away after cutting.
Figure 4-5.4a
Figure 4-5.4b
Figure 4-5.5a
90°
Metal locker
Figure 4-5.5b
Summary of Contents for P12 10
