17
short, flat stock only. To adjust, remove the four
tension adjusting screws, keeping track of screw
penetration into retaining nut. Slide rollers in toward
drum using retaining nut closest to drum. Reinstall
four adjusting screws with the same tension or
penetration into retaining nut. See page 26.
Flat Surfaced Stock:
Loosen the four socket head
screws holding the tension roller brackets. Place
stock under brush. Lower brush to proper bristle
penetration. Raise brush two-to-three revolutions.
Tighten the four socket head screws. Remove stock,
lower brush head to previous setting when adjusting
and brush material.
Bristle Contact:
Proper bristle penetration is critical
for the best finish and longest brush life. Flatter brushes
should be set to penetrate between 1/8 to ¼” into
the deepest part of the profile being sanded. Nylon
brushes should be set to penetrate approximately
1/16” into the deepest part of the
profile being
sanded. Wire brushes should be set to penetrate 1/32
to 1/16” into the material being brushed.
Selecting Brush Stock Feed Rates
Selecting the proper feed rate is essential to proper
Brushing and sanding. Feed rate controls the duration
or “dwell time” of brushing on the contact area. A
slower feed rate allows more brushing to occur. In
some instances, a slow feed rate and slow brush speed
may produce the same result as a fast feed rate and
fast brush speed. The variable feed rate control of
the conveyor belt adjusts the load on the machine;
it can be infinitely adjusted for maximum operating
Fig. 11 Tension rollers and adjustment bracket
Fig. 11A Tension roller height and depth gauge adjustment
performance. A faster feed rate allows faster brushing
but fewer revolutions of the brush per inch of sanding.
A slower feed rate provides more revolutions of the
brush per inch of sanding (Fig. 10).
The best feed rate will depend on several factors,
including type of stock, brush, depth of cut used,
and whether the stock is fed directly in line with the
conveyor bed or at an angle. When testing feed rates,
begin with a mid-range (50%) setting and adjust faster
or slower depending on conditions and performance.
Drum Sanding Feed Rates
Selecting the proper feed rate is essential to proper
finish sanding. For finish sanding the best finish is
usually achieved with a slow to moderate feed rate,
after the proper depth of cut has been determined.
This allows for the most revolutions of the drum per
inch of sanding. When abrasive planning, faster feed
rates can be used as long as the machine is not over
stressed. Please note, angling stock as it is sanded
will allow the most effective stock removal and
least loading of the abrasives. Feeding stock straight
through yields the widest sanding capacity and least
noticeable scratch pattern.
Please note; when drum sanding with RPM adjusted
to fastest speed, INTELLISAND will automatically
adjust the conveyor feed rate if an excess load is
detected. This prevents excessive gouging, reduces
the risk of burning and it protects the machine from
overload or stalling. The red light by the adjustment
Summary of Contents for SuperMax 19-38 Combo
