LAGUNATOOLS.COM
17
4. Loosen the four nuts then the four set screws locking the table support
casting, Fig. 5. Finger tighten these same set screws. Hold the set screw
with a Hex wrench and tighten the nut. Note, these set screws are brass
tipped and are designed to lightly rub on the column.
Figure 5: Table Support Set Screws
NOTE: There are four motor support screws pre-set at the factory.
Adjustable for maintenance purposes, if necessary.
Figure 6: Motor Support Set Screws
Motor Support
Set Screws (2 for
each motor, 4
total)
Table Support Set
Screws (4 each side,
8 total)
Summary of Contents for SuperMax SuperBrush 24 x 2
