LAGUNATOOLS.COM
32
Conveyor
Symptom
Possible Cause
Solution
Conveyor rollers run
intermittently.
1. Shaft coupling loose.
Align shaft flats of gear
motor and drive roller;
tighten shaft coupling
set screws.
Conveyor belt slips on drive roller
1.
Improper conveyor
belt tension.
2.
Excessive depth of cut
Adjust belt tension .
Reduce depth of cut;
reduce feed rate.
Stock slips on
conveyor belt.
1. Excessive depth of cut.
Reduce depth of cut.
2. Tension rollers too high.
Lower tension rollers.
3. Excessive feed rate.
Reduce feed rate.
4. Dirty or worn conveyor belt.
Clean or replace conveyor
belt.
Conveyor belt tracks to one side, or
oscillates from side to side.
1.
Belt out of adjustment.
2.
Drive or driven conveyor
belt rollers misaligned.
3.
Conveyor table not flat
and square.
4.
Conveyor belt worn.
5.
Drive roller worn
or damaged.
6.
Roller
bushings/bearings
elongated due to
excessive wear.
Readjust belt.
Readjust.
Readjust by
leveling machine.
Replace conveyor belt.
Replace drive roller.
Replace
bushings/bearings.
Summary of Contents for SuperMax SuperBrush 24 x 2
