Machine Set-Up
25
Before altering this conveyor table position, also check to see that the rear drum is likewise parallel to the conveyor
table, with both sides at the same height above the table. Using the same thickness gauge, check both sides of
the rear drum from the rear of the machine while holding up the rear tension roller. Adjustment of the rear drum is
done by using the right and left drum adjustment knobs
(See Figure 9)
.
After the rear drum is adjusted, it is important to:
a.) Reset the Rear Drum adjustment indicators to zero on both sides.
b.) Set the secondary drum adjustment indicators by loosening hex nut, then moving
the indicator scale so that
the zero mark is directly under the needle and retightening the hex nut (See Figure 9)
. Likewise, zero the
indicator for other side of drum.
Take care not to overtighten the hex nut of the indicator. This can flare the
brass bushing and render the indicator inoperable.
c.) Check that the secondary drum adjustment knobs turn with a slight resistance to avoid any movement during
operation.
Summary of Contents for 37 x 2
