Double Drum Sander 37 x 2
38
If you
observe a ripple effect
on the stock,
slow down the feed rate
. If the finish is smooth and the machine is
not overworking, you can experiment with using a faster feed rate. Also try a faster feed rate if the stock you are
working begins to show burn marks.
Types of Woods such as:
•
Cherry,
•
Hard Maple and some other hardwoods.
Use a shallower or lower depth of cut and a faster feed rate will help minimize burn marks. Slightly angling the
stock as it is fed into the machine may also help prevent burning the stock.
Because of the wide range of variables, it is important to experiment with your specific conditions and adjust
achieve the optimum feed rate. If problems occur, first check the depth of cut and/or adjust the feed rate.
Refer to the
Troubleshooting Parameters of the SUPERMAX
in this manual.
USING THE DEPTH GAUGE:
The
Depth Gauge (See Figure 16)
measures the distance between the conveyor table and the sanding drum for
thickness dimensioning of boards. To calibrate the depth gauge, raise the conveyor table until the drum(s), wrapped
with abrasive, touches the conveyor table. Loosen the two slotted screws holding the indicator needle to the table
mount bracket
(Figure 16)
. Raise or lower the indicator needle to read at zero and tighten the two slotted screws.
USING THE DRO (Digital Read-Out) DEPTH GAUGE:
The
DRO Depth Gauge (Page 44, Fig. 45A)
has its own manual. The DRO Scale can be calibrated by raising the
conveyor until the Drum(s) are touching the conveyor and zero the readout. Another calibration method is to sand a
piece of wood, measuring the thickness of the wood and change the reading on the DRO Scale.
See included DRO Scale manual for details on calibrating and operation.
Summary of Contents for 37 x 2
