Mainteance
49
Readjustment Procedures
Readjustment Procedure:
1.)
Loosen the set screws located at the front of the table support castings
(See Figure 19)
.
2.)
Lubricate thoroughly by applying penetrating lubricant to the table support castings where they contact the
column tubes, and to all contact points of adjusting screws and cross bar
(Figure 20)
. Also apply oil or grease to
the miter gears.
3.)
If the height adjustment feels stiff, check for misalignment of adjusting screw supports and the drum support
castings which could cause binding on the adjusting screw rods
(See Figure 19)
. These castings can be adjusted
by loosening the set screws which secure them to the column tubes. Realign the adjusting screw supports by
loosening the 2-two set screws that hold them to the column tubes and rotate to the proper position.
4.)
The Adjusting Screw Supports located immediately below the height adjustment handle and the left (outboard)
drum supporting casting
(See Figure 19-Below)
must both be set at the proper height along the column tubes so
the height adjusting screws provide for proper miter gear alignment. Before adjusting these parts, tighten one set
screw in the table support castings
(See Figure 19)
to hold the height adjusting screw in position during
adjustment. Also check to see that the column tubes are centered inside the bore of the table support castings
(See Figure 19)
. If not, loosen the casting bolts and tighten the set screws at the front of table support casting to
center the tube. Retighten the bolts and loosen the set screws.
Summary of Contents for 37 x 2
