Double Drum Sander 37 x 2
50
5.)
If the Height Adjustment Mechanism feels rough, check the miter gear
(See Figure 20)
alignment. The miter
gears can be adjusted on their shafts by loosening the set screws on the gears. Check and adjust so that the gear
mesh is not too tight or too loose, and that the gear teeth align with the opposing gear. Note that the shaft collars
located on the cross bar
(See Figure 21)
should be adjusted to control the lateral movement of the cross bar to maintain accurate miter
gear alignment and mesh. The mesh of the miter gears should be smooth and even. If not, adjust the gears for good
mesh
(Figure 20)
. Measure the space between the miter gear and the adjusting screw support that holds the
height adjusting screw in place
(Figure 21)
. The distance should be 1/32" or less. If there is excessive space,
move the adjusting screw support to the proper distance above the miter gear and retighten. Loosen the set screws
in the table support castings
(Figure 19)
and test for smooth operation.
6.)
Next, check the position of the height adjusting screw rods. First raise the conveyor table. Then check the E-
clip and washer at the top of the height adjusting screw on the left (outboard) side, and under the height adjustment
handle on the right (inboard) side of the machine. On both sides, the washer and E-Clip (or washer-only) should be
snug on the casting just below the washer. If there is a space between the washer and the casting, tighten one set
screw in each of the table support castings. If one height adjusting screw is loose, remove the miter gear from the
cross bar on that side. Turn down the threaded height adjusting screw rod until it is snug with the washer. Make
sure both sides are snug on top. Reinstall the miter gear and tighten. Loosen the set screws in the table support
castings and test for smooth operation.
Summary of Contents for 37 x 2
