Rotating/Replacing Drum Bearings
69
collar, then tighten the set screws and then the bearing flange
(See Figure 40)
.
2.)
Next, check the alignment of the drums to the conveyor system.
(For instructions on this procedure, see
pages 17 and 18 of this manual.)
Make sure the drums are parallel to each other.
3.)
Reinstall the V-belt on the motor pulley and adjust its tension. Then reinstall the pulley guard.
4.)
Test-Run the sander before sanding stock to recheck that all is operating properly and is aligned before sanding
good stock. Also, stop the sander after a couple of hours of use and check the bolts and set screws to make sure
they are seated properly.
REPLACING ELECTRICAL COMPONENTS:
To replace either the
“Variable-Speed Intellisand Control,”
the
“On-Off” Switch
, or the
Conveyor Motor
, use
the following disassembly procedure
(See Figure 45 and 45a)
:
To replace either the
“Variable-Speed Intellisand Control,”
the
“On-Off” Switch
, or the
Conveyor Motor
, use
the following disassembly procedure:
1.)
Disconnect the Power Supply to the machine.
2.) Remove the bottom plate from the Control Box.
3.)
Loosen the set screw in the shaft coupler, and then remove the 4-four 5/16" bolts that hold the conveyor motor
assembly in place
(See Figure 45)
.
Summary of Contents for 37 x 2
