Double Drum Sander 37 x 2
70
4.)
Remove the assembly from the machine, then turn it upside down to disconnect the leads from the components
to be removed.
5.)
To replace the
“Intellisand Control”:
Remove the knob by loosening screw and remove nut that was under
knob. Turn housing over and remove the nuts holding control board in place.
6.)
Lift control board from housing. Install the new controller, referring to the correct electrical diagram and reverse
the disassembly procedure.
7.) To replace the
“On-Off Switch” (See Figure 45)
:
a.) Remove the 2-two screws holding cover in place.
b.) Pull Switch from Box.
c.) Disconnect wire leads from switch and remove cover plate from switch.
d.) Referring to the
Correct Electrical Diagram,
reverse the disassembly procedure.
8.)
To replace the
“Gear Motor”
:
a.) Disconnect the three wire leads from the controller.
b.) Disconnect the plastic grommet protecting the wires passing through the sheet metal.
c.) Remove the 4-four set screws that hold the motor to the sheet metal bracket.
d.) Remove the old motor and install the new motor.
e.) Referring to the
Correct Electrical Diagram
, reverse the disassembly procedure.
Summary of Contents for 37 x 2
