21
T
ROUBLESHOOTING
Any operating problems with the S
UPER
M
AX
sanding performance, check the following listings
drum sander will likely occur most often during
for potential causes and solutions; it may also pay
the period that you are becoming familiar with its to review the previous sections in this manual on
components and their adjustments. If you are
setting up and operating your machine.
experiencing a problem affecting the machine’s
T
ROUBLESHOOTING
G
UIDE
: M
OTORS
Problem
Possible Cause
Solution
Motors do not start.
1. Main power cord
Plug in primary power
unplugged from receptacle.
cord.
2. Circuit fuse blown or circuit
Replace fuse or reset
breaker tripped.
breaker (after
determining cause).
Drum motor
overloads.
1.
Inadequate circuit.
2.
Machine overloaded.
Check electrical requirements.
Use slower feed rate and/or
reduce depth of cut.
Conveyor
motor oscillates.
1.
Motor not properly
aligned.
2.
Shaft collar worn.
3.
Drive roller bent.
Loosen housing bolts,
run motor, retighten bolts.
Replace shaft collar .
Replace drive roller.
Drum motor
or conveyor gear
motor stalls.
1. Excessive depth of cut.
Reduce depth of cut;
reduce feed rate.
Summary of Contents for 37x2
