26
JX|6 & JX|8 Quadtec:I Jointers \ Maintenance
Outfeed Table Adjustment:
WARNING
·
TURN OFF AND DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS!
The outfeed table is adjusted at the factory to be level with (or within .006” of) the Top Dead Center (TDC) of
the knife inserts.
To adjust the Outfeed Table, loosen the Adjustment Lock (Fig. 24) for the Outfeed Table with an 8mm hex
wrench (not included). Adjust the height of the Outfeed Table with the Adjustment Handle for the Outfeed
Table (Fig. 24). Tighten the Adjustment Lock.
FIGURE 24: OUTFEED TABLE ADJUSTMENT
Poly Drive Belt Adjustment:
WARNING
·
TURN OFF AND DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS!
The poly-drive-belt tension is set at the factory.
Proper tension is achieved when the belt can be
depressed approximately 1/4” mid-way between
the pulleys.
If adjustment is needed remove the four screws
holding the back panel to the stand of the jointer.
FIGURE 25: TWO OF THE FOUR MOTOR MOUNTING BOLTS
The motor is attached with four bolts on a slide. Loosen the four motor mount bolts to tension the drive belt
by sliding the motor downward (Fig. 25).
When the drive belt is properly tensioned, tighten the four motor mounting bolts and replace the back cover.
Summary of Contents for 506601
