-8-
www.igmtools.com
Pic. 14
Step 10: Slide the Foot pedal bar into the opening on the lower upright
support panel (R). Make sure the end of the bar is on the inside of the
triangular support plate. Follow the same steps for the opposite side.
Pic. 15
Step 11: Secure the foot pedal support to the lower upright support panel
using carriage bolts (4) 8 mm*13 mm, flat washers (4) 8 mm*OD18*2T
and hex nuts (4) 8 mm. Then secure the foot pedal bar to this support
using hex bolts (4) 8 mm*44 mm, flat washers (8) 8 mm*OD18*2T and hex
nuts (4) 8 mm. Same for the opposite side.
Pic. 16
Step 12: Secure the base of the foot pedal bar to the triangular support
plate by holding the lower support plate vertically up against the foot pedal
bar using hex bolts (2) 8 mm*1,9 mm, flat washers (4) 8 mm*OD18*2T
and hex nuts (2) 8 mm. Follow the same steps for the opposite side.
Pic. 17
Step 13: Attach the two ends of the Octagon foot pedal to the nut on the
foot pedal bar.
Pic. 18
Step 14: Secure the topping to the nut on the foot pedal bar. Follow this
step on the opposite side.
Pic. 19
Step 15: Secure the topping with (2) M8*30mm hex bolts.
Pic. 20
Step 16: Align the bolt hole on the movable supporting brace on the foot
peddle bar with the bolt hole on the octagon foot peddle.
3HP Mobile Dust Cyclone Manual
18
Step Eight: With the help of another person, lift the unit up carefully to the
right side up with the motor on top and the wheels at the bottom.
Step Nine: Secure the lower triangular support plate to the base using
(4)
5/16”*3/4” hex bolts and (4) 5/16”*OD18*2t flat washers
.
Follow the same steps
for the opposite side.
19
3HP Mobile Dust Cyclone Manual
21
Step Fourteen: Secure the topping to the nut on the foot pedal bar. Follow this
step on the opposite side.
Step Fifteen: Secure the topping with
(2) M8*30mm hex bolts
