13
If you are fitting the drift master on your own, it is recommended that the table
be removed to reduce the weight and ease assembly. If you have help with the
assembly, you can skip the removal process.
Remove the Allen screw from the end plate and remove the plate. The plate has
a small screw that lines up with a hole in the shaft. This is used for location
only.
Do not
remove the screw.
Disengage the lead screw with the lead screw engage/disengage lever. Slide the
table assembly off the shaft.
The shaft has four tapped holes to suit various table hole configurations. When
selecting which holes are best suited for your configuration, the following must
be taken into account:
1.
Do not have the universal brackets covering the blade slot.
2.
The universal brackets must not hang down so far that they restrict the lower
door from opening.
3.
The drift master must be positioned to give the maximum coverage.
Allen
screw
Summary of Contents for DriftMaster
Page 6: ...7 Parts of the drift master 4 9 12 13 10 8 7 6 5 4 3 2 1 11...
Page 28: ......