14
Shaft shown fitted to the universal mounting brackets
Using a 19 mm socket wrench, fit the shaft to the two fixing bolts in the holes
that you have selected. The holes have tapered threads, and the bolts will jam
into the tapers.
This is important, as it will enable you to tighten the lock nuts at a later stage,
and depending on your configuration, you may not have access to the back of
the universal mounting bracket.
Do not
tighten the lock nuts at this stage.
Fence support table End plate
Slide the table onto the shaft and lead screw. Refit the end plate.
Adjust the shaft and the universal mounting brackets so that the fence support
table is approximately level with the top of the band saw table and that the shaft
is positioned to give the coverage required. Snug tight the lock nuts and the
table mounting bolts. You do not have to fully tighten at this stage, as the shaft
Summary of Contents for DriftMaster
Page 6: ...7 Parts of the drift master 4 9 12 13 10 8 7 6 5 4 3 2 1 11...
Page 28: ......