20
It is not important that the fence is flush with the support table, but it is an
advantage, as it will mean that the gap under the fence will be maintained when
you change from the low to the high position.
Drift master shown with universal brackets Engineers square
Using an engineer’s square, check that the fence is square to the table.
If the fence needs adjustment, elongate one hole and adjust the drift master
either up or down, depending on the error.
Using the drift master.
Adjusting handle on either side of the fence.
The adjusting handle can be fitted to either side of the drift master. It is
supplied fitted to the left hand side, as this will suit most machines. To change
the handle to the right hand side:
Allen screw
1.
Remove the Allen screw from the end plate and remove the plate. The plate
has a small screw that lines up with a hole in the shaft. This is used for location
only.
Do not
remove the screw.
Summary of Contents for DriftMaster
Page 6: ...7 Parts of the drift master 4 9 12 13 10 8 7 6 5 4 3 2 1 11...
Page 28: ......
