21
Handle fitted on the Right hand side
2.
While holding the handle, loosen the nut and remove the handle. The handle
fits onto two flats on a threaded bush. Try not to rotate the handle with the nut
removed, as this will change the clearance between the nut and the threaded
bush.
3.
Remove the Allen screw from the end plate and remove the plate. The plate
has a small screw that lines up with a hole in the shaft. This is used for location
only.
Do not
remove the screw.
4.
With the lead screw engage/disengage lever in the disengaged position,
remove the lead screw from the drift master.
End plate Threaded bush
Handle, washer and nut fitted
5.
Fit the lead screw to the drift master from the opposite direction.
6.
Fit the end plate.
7.
Fit the handle end plate.
Summary of Contents for DriftMaster
Page 6: ...7 Parts of the drift master 4 9 12 13 10 8 7 6 5 4 3 2 1 11...
Page 28: ......
