DT-18 DOVETAIL
16
Electrical Safety
CONNECT POWER WIRES:
1.) Before connecting the machine to your factory power source, be sure the voltage of your power source complies
with the machine voltage.
The electric information for the machine, such as voltage, HZ pre-wired before shipment is indicated on the electric
instruction label, attached on the machine.
2.) Put electric wire with R.S.T connecting.
3.) The machine must be properly grounded to prevent possible damage from electric shock.
4.) The machine must be properly grounded to prevent possible damage from electric shock-The ground is green.
5. The power wire connection job must be performed by a qualified electric technician.
6. After connecting, you must make sure if it connects in the correct point or not.
SAFETY RULES FOR THE ELECTRICAL CONTROL SYSTEM:
1.) All electrical/electronic trouble shooting, and repair should be made only by a personal who is properly trained
and have adequate knowledge.
2.) Do not alter or bypass protective interlocks.
3.) Take extra precautions in some areas to prevent yourself from accidental grounding.
4.) When performing trouble shooting make sure the power source has been disconnected.
5.) Do not open the electric control panel unless it needs to check the electric components.
6.) Before applying power to any equipment it must be established without a doubt, that all persons are clear.
7.) Do not alter the electrical circuits unless authorized to do so by the machine manufacturer.
8.) When replacing electrical components, make sure they conform to the manufacturer’s specifications, including
proper color coding.
9.) All covers on junction box must be closed before leaving any job.
Summary of Contents for DT-18
