Fusion F3 Table Saw - Maintenance -
46
© 2020 Laguna Tools
Maintenance
Never perform and setup, maintenance or adjustment procedures with the machine connected to the power
source!
If you have any doubt about the described procedure, seek professional assistance. Do not attempt any
procedure that you feel is unsafe, or that you do not have the physical capability of achieving.
When removing banding, extreme caution must be used as the banding will spring when cut.
The machine is heavy. Ensure that you have enough people to do the job safely.
There may be sawdust in or around your new machine as a result of thorough testing.
General
Keep your machine clean. At the end of each day, clean the machine. Wood contains moisture, and if sawdust or wood
chips are not removed, they will cause rust. In general, we recommend that you only use a Teflon-based lubricant on the
saw. Regular oil attracts dust and dirt. Teflon lubricant tends to dry and has less of a tendency to accumulate dirt and saw
dust. Periodically check that all nuts and bolts are tight.
Drive belt
The drive belt should last for many years (depending on the usage) but needs to be inspected regularly for cracks, cuts and
general wear. If damage is found, replace the belt.
Bearings
All bearings are sealed for life and do not require any maintenance. If a bearing becomes faulty, replace it.
Rust
The saw is made from steel and cast iron. All non-painted surfaces will rust if not protected. It is recommended that they be
protected by applying wax or a Teflon- based lubricant to them.
Daily Check:
·
Loose mounting bolts
·
Damaged saw blade
·
Damaged riving knifes, splitters, or blade guards
·
Worn or damaged wires
·
Any other unsafe condition
Weekly Maintenance:
·
Clean table surface and miter slot grooves
·
Clean and protect cast iron table
·
Clean rip fence
Monthly Maintenance:
·
Clean/vacuum dust buildup from inside cabinet
and off motors.
·
Check/replace belt for proper tension, damage or
wear
Every 6–12 Months:
·
Lubricate trunnion slides.
·
Lubricate worm gear.
·
Lubricate leadscrew.
·
Lubricate gearing and gearboxes.
Summary of Contents for Fusion F3
