laguna Laguna Series, Manual

Emergency stop 

button 

Start button 

Controller Note may vary 

from that shown 

Controller Button Functions

X+ / 1 

= Moves the gantry in the X direction away from the home 

end of the bed.

Y+ / 2 

= Moves the gantry in the Y direction away from the home end 

of the bed.

Z+ / 3 

= Moves the router head in the Z [Up direction] away from the 

table surface.

XY-0 / 4 

= Sets machine “Origin”.

X- / 5 

= Moves the gantry in the X direction towards the home end 

of the bed.

Y- / 6

 = Moves the router head in the Y direction towards the home 

end of the bed.

Z- / 7 

= Moves the router head in the Z [Down direction] towards the 

table surface.

Z-0 / 8 

= Is used to set the tool to the “Zero” surface [tool “touch-off”].

HOME / 9

 = Causes the machine to move to the “Home” position, First in the Z axis, 

followed by X and then Y. [Home is a mechanically determined position using mechanical 

switches/sensors.]

HIGH/LOW / 0 

= Toggles jogging speeds between High and Low ranges.

ON/OFF 

= Turns the Router Spindle On and Off.

MENU / _ 

= Provides access to various setup features.

ORIGIN /OK

 = Use to accept commands [“On”]. Origin causes machine to return to the 

machines “Origin”.

MODE

 = Toggles between the three jogging modes: Continuous, Step or Distance.

RUN PAUSE / DELETE

 = Used to load a program from either the USB drive or

internal memory. While the program is running, causes the Operation to “Pause”.

STOP / CANCEL 

= Stops a running program. Also used to cancel commands.

Turning on the Machine

Note:

 Before you turn on the machine remove all tools and other objects 

from the machine table.

Release the emergency stop by twisting clock wise and it will pop out.

Press the green start button, this will turn power on to the machine.

Pressing the green button will also power the controller and the display 

will light up.

The screen will display “Go to Home?”

Ensure that the table surface is clear of obstructions and press the 

green Origin/OK button.

The router head will move to the home position on the table.

Note: 

“Home” is a mechanical position that is a constant determined 

by switches on each of the 3 axes.

X+= Across [from left-to-right when standing in front of the machine]

Y- = Length [from front-to-back when standing in

front of the machine]. Should this be Y+?

Z+= vertical [up].

By pressing HIGH LOW / 0 and MENU / - the display will change to 

AX=0, AY=0, and AZ=0. When the X, Y and Z have an A in front, this

denotes that the dimensions displayed are in reference to the 

machine’s home position. When the X, Y, and Z values are displayed 

with a number [1-9] this indicates the dimensional relationship of the 

machine from the machine’s “Origin”.

16