laguna Laguna Series, Manual

To Move the Router Head

There are 3 different methods of moving the router head.

1. 

Continuous mode.

 Press the mode button until “Continuous” is displayed.

The display will show [bottom row of the screen] the changing location of the

router head as it moves location. By holding X+ button down the machine will

move continuously until the button is released. This is the same for X-, Y+, Y-, Z+

and Z-. The “High/Low” button determines the speed of the jogging moves.

2. 

Step mode. 

Press the mode button until “Step” is displayed. With Step

selected, each time the X, or Y button is pressed it will move the router head by

0.5mm in the high setting and 0.1mm in the low setting.

3. 

Distance mode.

 Press the mode button a third time and “Distance” is

displayed. This allows you to input the position into the controller that you want

the router spindle to move to.

As an example: If you want to move the router spindle 100mm from the home

position in the X and / or Y axis:

1.  

Press the mode button until Distance is displayed.

2.  

Type in 100 and press OK

3.  

Pressing the X+= button will now move the router 

  100mm in the X+axis.

The router head also moves the set distance in the X+, X-, Y+ and Y- depending

on which buttonis pressed.

To move the router head in the Z axis press the Z+= / 3 [ UP] or the Z- / 7 button

[DOWN].

By pressing any of the other X, Y or Z, + or – buttons, the router head will move

100mm in the selected direction.

Jogging Speed

You can select between a Low or High speed. By pressing the HIGH LOW / 0

button you can toggle between the two speeds. The High speed jog setting is

approximately 4 times the speed of Low speed jog setting.

17