12
PX|22 Sheartec:II Planer \ Electrical Safety
Check with a qualified electrician or service personnel if the grounding instructions are not completely
understood, or if in doubt as to whether the tool is properly grounded.
Use only 3-wire extension cords that have 3-prong grounding plugs and 3 pole receptacles that accept the
tool's plug.
Repair or replace damaged or worn cord immediately.
2. Grounded, cord-connected machines intended for use on a supply
circuit having a nominal rating less than 150 volts:
This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in Fig. A. The
tool has a grounding plug that looks like the plug illustrated in Fig A. A temporary adapter, which looks like
the adapter illustrated in Fig B may be used to connect this plug to a 2 pole receptacle as shown in Fig B if a
properly grounded outlet is not available. The temporary adapter should be used only until a properly
grounded outlet can be installed by a qualified electrician. This adapter is not permitted in Canada. The
green-colored rigid ear, lug, and the like, extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box.
3. Grounded, cord-connected tools intended for use on a supply circuit
having a nominal rating between 150 – 250 volts, inclusive:
This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in Fig C. The
tool has a grounding plug that looks like the plug illustrated in Fig C. Make sure the tool is connected to an
outlet having the same configuration as the plug. No adapter is available or should be used with this tool. If
the tool must be reconnected for use on a different type of electric circuit, the reconnection should be made
by qualified service personnel; and after reconnection, the tool should comply with all local codes and
ordinances.
Summary of Contents for PX|22 Sheartec:II
