32
Revo 18|36 Lathe \ Setup Assembling the Lathe
Underside of bed
Banjo Post hole & Tool Rest post
Cam Lock Washer; Headstock,
Tailstock, Banjo
NOTICE!
If it is discovered that the tool rest post does not stay in place when using, it is because of a
lubricant within the clamp (banjo post hole and tool rest post). To remedy this, clean off any grease or oil
with a shop rag. An anti slip friction paste can be used to further hold the post.
The Tailstock, Headstock and Banjo all use the same cam locking mechanism. The nut underneath the
mechanism should be adjusted such that the clamp handle locks with approximately 30 degree of
movement.
Un-assembled
Washer fitted
underneath bed
Nut
Clamp Handle
1. Install the Tailstock to the bed, then install the quill knob to the tailstock.
2. Install the Banjo to the bed.
