Assembling Instruction
Warning:
The lathe must be disconnected from power source during assembly.
Legs Installation (Fig. 2)
1, Life the lathe off the pallet by using a hoist or forklift. Place it on a table or workbench
with sufficient clearance to allow the support legs to be attached from underneath.
2, Attach the legs to the bed by using 12mm hex head bolts A with washer B. Firmly
tighten the bolts.
3, After firmly securing the legs to the lathe, carefully lower the lathe onto the floor.
4, Adjust the leveling feet to ensure all four feet sit firmly on the floor. Make sure that the
lathe does not rock.
Fig. 2
Tool Storage Bracket (Fig. 3)
The tool storage bracket D can be mounted to the left end of the lathe. Use two 12mm
head cap screws A with flat C and spring washers B to secure it to the lathe.
Fig. 4
Fig. 3
