9
Note:
The Intellisand™ Control (Fig. 5) reduces
the chance of potential damage from many
overload situations. The conveyor motor for
feeding stock is infinitely variable from 0-15
ft/min. If the load on the drum motor reaches its
upper limit, the Intellisand Control will
automatically slow the feed rate of the conveyor.
When the load is decreased on the main motor, the
feed rate will automatically increase but never
exceed the manual setting on the dial.
C
ONNECTING
D
UST
C
OLLECTORS
Dust collection is necessary for all models. The
S
UPER
M
AX
37x2 model is equipped with three
4" dust exhaust ports.
To attach the sander
to your collection sys-
tem, install 4
"
hose from your collector. (See Tips
For Maximum Performance). The
minimum
recommended dust collector capacities at the
dust ports are:
25x2: 600
CFM
. For best results,
follow the recommendations of the manufacturer
of your dust collection equipment.
C
HECKING
D
RUM
A
LIGNMENT
The sander was shipped from the factory
preadjusted with the drum(s) aligned to the con-
veyor table. Unless the machine was stressed dur-
ing shipment, only fine adjustment should be nec-
essary. Minor alignment corrections can be done
without relieving V-belt tension or adjusting the
tension rollers, but should be done without any
abrasive strips attached.
Fig. 4. Checking drum alignment (inboard side).
Fig. 5. Intellisand Controller.
Remove the abrasives from both drums. Using
a flat piece of wood or aluminum as a thickness
gauge (aka. feeler gauge), insert it between the
conveyor table and the primary (front) drum on
the left (outboard) side of the machine (see Fig.
4). Raise the table up so the drum just contacts the
thickness gauge. Rotate drum by hand to check
contact. Then, holding up the front tension roller,
check at out-board side of the drum to see that
the drum is parallel to the table. If it is not,
disengage
Summary of Contents for SuperMax 25x2
