LAGUNATOOLS.COM
10
Wear respirator.
Fine dust that is too small to be caught in the filter may
be introduced into the ambient air during operation. Always wear a NIOSH-
approved respirator during operation and for a short time after to reduce
your risk of permanent respiratory damage.
Disconnecting power supply.
Turn the switch off, disconnect from the
power supply, and allow machine to come to a complete stop before leaving
the machine unattended or doing any service, cleaning, maintenance, or
adjustments.
Suspended dust particles and ignition sources.
Do not operate in
areas
were explosion risks are high. Areas of high
risk include, but are not limited
to, areas near pilot
lights, open flames, or other ignition sources.
Fire suppression.
Only operate in locations that contain a fire suppression
system or have a fire extinguisher nearby.
Static electricity.
Plastic dust lines generate high amounts of static
electricity as dust chips pass through them. Although rare, sparks caused by
static electricity can cause explosions or fire. To reduce this risk, make sure
all dust lines are thoroughly grounded by using a grounding wire.
Regular cleaning.
Regularly check the machine for excessive dust and
debris and clean. Make sure to regularly clean the surrounding area where
the machine is operated
—
excessive dust buildup on overhead lights, heaters,
electrical panels, or other heat sources will increase the risk of fire.
SAVE THESE INSTRUCTIONS.
Refer to them often and use them to instruct others.
Please read and save these instructions. Read carefully before attempting to
assemble, install, operate or maintain the product described. Protect yourself
and others by observing all safety information. Failure to comply with
instructions could result in personal injury and/or property damage! Retain
instructions for future reference.
DO NOT EXPOSE THE MACHINE TO RAIN OR OPERATE THE MACHINE IN
DAMP LOCATIONS.
Summary of Contents for SuperMax SuperBrush 49
