LAGUNATOOLS.COM
14
To assemble your SuperBrush 49, follow these steps:
For your own safety, do not connect the machine to the power source until
the machine is completely assembled. Please also make sure that you read
and understand the entire manual.
1. Make sure the four locking set screws in the Table Support Casting are
tight. Unbolt machine from pallet. Using a forklift, lift the SuperBrush 49
from the pallet. The forks should lift from under the conveyor support cross
members. Be careful when placing the forks not to damage other areas or
wiring, Fig. 3 & 5.
Figure 3: Table Support Set Screws
2. Attach the four casters to the legs of the machine by using the included
bolts and washers through each hole of the caster (from the bottom-up) into
the leg of the machine, Fig. 4. Start all four bolts and washers before
tightening the bolts.
Summary of Contents for SuperMax SuperBrush 49
