LAGUNATOOLS.COM
16
4. Loosen the four nuts then the four set screws locking the table support
casting, Fig. 5. Finger tighten these same set screws. Hold the set screw
with a Hex wrench and tighten the nut. Note, these set screws are brass
tipped and are designed to lightly rub on the column.
5. Loosen the two set screws in the motor support casting, Fig. 6. Important:
Loosen these set screws before attempting to raise or lower motor for brush
installation!
Figure 6: Motor Lock Set Screws
6. Check tightness of all hardware.
NOTE: shipping can loosen nuts, bolts and set screws.
7. Remove shipping shaft from brush machine, Fig. 7;
A. Loosen drive belt by raising motor with motor tension handle on top of
the column near drive belt.
B. Slide drive belt off pulley.
C. Remove two bolts from each bearing.
D. Remove shipping shaft from brush sander.
E. Loosen set screws in each bearing and driven pulley.
F. Slide pulley and bearings off shaft.
Motor Support
Set Screws (2)
Summary of Contents for SuperMax SuperBrush 49
