3
Dear customer,
Congratulations for buying the SNIPER II model helicopter from LA-Heli production. The SNIPER
is suitable for basic training as well as for full 3D exhibition flying. Its excellent design enables the
model’s behavior and stability to be varied by changing the setup and main blades.
NOTICE !
An RC model helicopter is not a toy. Use the utmost care, attention and prudence when
you fly or repair it. A helicopter contains fast rotating parts which can cause serious harm
or injuries. Do not fly the machine with any potential technical problems. Do not fly at
places which are not explicitly suitable for flying models.
Model assembly
If you are not experienced with model helicopters, we advise you to find skilled help. The
assembly, and in particular the setup, of an RC helicopter is not a straight forward job; it requires
some experience.
It is necessary to secure screws with anaerobic glue (Loctite) in many assembly steps.
Every such place is marked with green glue symbol in the exploded views. Do not
underestimate the importance of this operation. The Sniper is built from metal and carbon
composite materials. Most of the screwed joints must be secured against the effects of
vibration.
Equipment required to build the Sniper, which is not included:
Allen wrench (1.5mm, 2mm, 2.5mm)
Cross-head screwdriver
Wrench 5.5mm
Anaerobic glue, recommended Loctite 242 (identified in text simply as “Loctite”)
5 minute epoxy
Other normal model/hobby tools
Recommended equipment
- 3x servo for swashplate (Futaba 3150, 3155, Hitec HS82MG, etc.)
- Motor (Laheli AXI PRO 282010, Kontronik KORA 15-10, etc.)
- ESC Heli-type with governor, 40-60A (Kontronik JAZZ 40-6-18, etc.)
- Gyro (Futaba GY-401 or similar)
- 1x fast servo for tail steering (Futaba 9257 or similar)
- Receiver (appropriate for RC system used)
