Lainox ME 061 P, User Manual

10.1 • DISPLAYING SETTINGS DURING

COOKING PHASE (without stopping)

Press the cooking cycles key, the displays

blink showing the previous settings. After
10 sec. the actual values reappear (TIME
OUT).

10.2 • CHANGING THE SETTINGS DURING

THE COOKING PHASE (WITHOUT
STOPPING)

10.3 • FORCING THE COOKING PHASES

OF A MANUAL PROGRAM WITH
MORE THAN ONE PHASE IN
SEQUENCE
If you wish to skip a cooking phase or
complete it sooner, press and hold the
cooking cycle key for approximately 5 sec.;
the display will automatically show the next
phase.

10.4 • TEMPORARY STOP 

O p e n   t h e   d o o r   o r   p r e s s   k e y   1 6 :   t h e
corresponding LED blinks. Cooking stops
and the timer pauses until such time as the
door has been closed or key 16 pressed a
s e c o n d   t i m e .   C o o k i n g   w i l l   r e s u m e
automatically from the point at which the
interruption occurred.

10.5 • FINAL STOP 

To stop or permanently interrupt a cooking
program for which infinite time is set, press
key  16 and hold for approx. 3 seconds.
A continuous beep confirms the end of the
cooking operation as if the full time had
elapsed, and the LED associated with
key 16 goes out.

10.2 a •
TEMPERATURE AND
TIME
To change the setting,
press the cooking cycle
key. Then turn the
relevant knob to set the
new value (increasing
to the right, decreasing
to the left); The
displays show the
settings that have just
been made, after 10
sec. the actual values
reappear.

10.2 b •
AUTOMATIC
HUMIDITY
CONTROL
Press the cooking
cycle key and then
press key 14 automatic
humidity control
function, (display 6
shows [ H.. ], set
previously). Turn knob
26 to make the new
setting. After 10 sec.
the actual values
reappear.

16

90024140rev00

OPERATIONS

FOREWORD 
D u r i n g   c o o k i n g   ( L E D   o n   s t e a d y )   t h e
displays show the actual values (current

status). It is anyhow possible to check the
settings. For this purpose, proceed as
follows:

10 • OPERATING DETAILS