Sentrius RG191+LTE
User Guide
https://www.lairdconnect.com/
19
© Copyright 2020 Laird Connectivity.
All Rights Reserved
Americas
: +1-800-492-2320
Europe
: +44-1628-858-940
Hong Kong
: +852 2923 0610
8
L
O
R
A
C
ONNECTION
S
ETUP
The side panel for the LoRa Gateway allows selections for configuration and status of the LoRa network card. The status of
the LoRa Network is also displayed (
).
Figure 19: LoRa connection setup page
The Gateway ID (also known as the gateway DevEUI), is used to uniquely identify the RG191+LTE gateway. It is required
when registering the gateway on a LoRa network server. The gateway EUI is also printed on the bottom label of the gateway,
with the label
M2 EUI or DevEUI
.
Figure 20: Gateway label (Standard GW
– Left, AS923 & AU915 Region Supported/Latest Version – Right)
8.1
Using Presets
The Sentrius
TM
RG191+LTE contains multiple preset configurations for connecting to a third-party server or as the basis for a
private network. These presets configure the forwarder and the channel plan.
To apply a preset configuration, follow these steps:
Click the
LoRa
tab in the main menu. The default page of the LoRa menu is the
Presets
page (also accessible in the
left side menu of the LoRa pages).
Select the preset from the drop down. Information about this preset is displayed in a panel to the right (
).
Click
Apply
to apply the preset configuration. After a few moments, a green confirmation appears on the bottom of the
page.
Note:
After applying a preset, further changes can be made on the other screens. Some presets use a custom
forwarder and may not be modified.
Note: The LoRa Region Code is
displayed here. Be sure that
the gateway you are
operating matches the region
in which you are operating it.
