https://connectivity.lairdtech.com
5
© Copyright 2019 Laird. All Rights Reserved
Americas
: +1-800-492-2320
Europe
: +44-1628-858-940
Hong Kong
: +852 2923 0610
To install the external temperature sensor, refer to Figure 2
and follow these steps:
Unscrew the Ethernet cap (1) from the Sentrius
Sensor.
Connect the RJ45 connector from the cable
assembly into the external port of the Sentrius
Sensor.
Screw on (by hand) the top portion of the cable
gland
– the screw nut (3) – until tight.
Visually check to ensure the lower portion of the
cable gland
– the pressing screw (2) – is also
tight.
Figure 2: Installing the external temperature sensor
Note:
Ensure that references (2) and (3) in Figure 2
are tight when installing the external temperature probe into the Sentrius
Sensor. If these areas are not sufficiently tightened, this could lead to a potential leak and cause damage to the sensor’s
external port connector or to the temperature probe cable assembly.
