www.lairdtech.com
T
HEORY
OF
O
PERATION
3
R F A R C H I T E C T U R E
The AC4868-250 is a single channel radio transceiver. Each unit can be configured as a Server or as a Client.
Servers are responsible for sending out beacons and for allow for radios to be configured very simply in a point-to-
multipoint network. Servers are not required for operation, but if they are used, there should only be one Server per
network. All other radios in the network should be configured as Clients. Clients can communicate point-to-point or
in a mesh with or without a Server.
M O D E S O F O P E R A T I O N
The AC4868-250 has three different operating modes; Receive, Transmit, & Command Mode. If the transceiver is not
communicating with another radio, it will be in Receive Mode actively listening for a beacon from the Server. If the
Client determines that the beacon is from a server operating on the same RF Channel and System ID, it will respond
by asserting In_Range Low. A transceiver will enter Transmit or Command mode when the OEM Host sends data over
the serial interface. The state of the Command/Data pin (Pin 17) or the data contents determine which of the two
modes will be entered.
T r a n s m i t M o d e
All packets sent over the RF are either Addressed or Broadcast packets. Broadcast and Addressed delivery can be
controlled dynamically with the API Control byte and corresponding on-the-fly commands. To prohibit transceivers
from receiving broadcast packets, Unicast only can be enabled.
A D D R E S S E D P A C K E T S
When sending an addressed packet, the RF packet is sent only to the receiver specified in destination address. To
increase the odds of successful delivery, Transmit retries are utilized. transparent to the OEM Host; the sending radio
will send the RF packet to the intended receiver. If the receiver receives the packet free of errors, it will return an RF
acknowledge within the same 53 ms hop. If a receive acknowledgement is not received, the radio will use a transmit
retry to resend the packet. The radio will continue sending the packet until either (1) an acknowledgement is received
or (2) all transmit retries have been used. The received packet will only be sent to the OEM Host if and when it is
received free of errors.
B R O A D C A S T P A C K E T S
When sending a broadcast packet, the RF packet is sent out to every eligible transceiver on the network. To increase
the odds of successful delivery, Broadcast attempts are utilized. Transparent to the OEM Host, the sending radio will
send the RF packet to the intended receiver(s). Unlike transmit retries, all broadcast attempts are used; regardless of
when the RF packet is actually received and without RF acknowledgements. If the packet is received on the first
attempt, the receiver will ignore the remaining broadcast attempts. The received packet will only be sent to the OEM
Host if and when it is received free of errors.
R e c e i v e M o d e
When a transceiver is not in Transmit or Command mode, it will be in Receive Mode listening for data. While in
Receive Mode, subsequent data of up to 80 bytes can be received every hop (53 ms).
electronic components distributor
