BT85x Series
Datasheet
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
28
© Copyright 2017 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
14
FCC
R
EGULATORY
Model
US/FCC
CANADA/IC
BT850-SA
SQGBT850
BT850-ST
SQGBT850
BT851
SQGBT850
DVK-BT850-SA
DVK-BT850-ST
The BT85x family has been designed to operate with the antenna listed below having a maximum gain of 0.5 dBi.
The required antenna impedance is 50 ohms.
Item
Part Number
Mfg.
Type
Gain (dBi)
1
AT3216-B2R7HAA
ACX
Ceramic
0.5
2
001-0030 mFlexPIFA
LAIRD
PIFA
2
3
001-0014 FlexPIFA
LAIRD
PIFA
2
4
0600-00040
LAIRD
Dipole
2
5
NanoBlue MAF94045
LAIRD
PCB Dipole
2
14.1.
Documentation Requirements
To ensure regulatory compliance, when integrating the BT850-Sx into a host device, it is necessary to meet the
documentation requirements set forth by the applicable regulatory agencies. The following sections (FCC,
Industry Canada, and European Union) outline the information that may be included in the user’s guide and
external labels for the host devices into which the BT850 is integrated.
IMPORTANT:
If the conditions above cannot be met (for example certain device configurations or co-location with
another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot
be used on the final product. In these circumstances, the OEM integrator will be responsible for re-
evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
When using Laird’s FCC grant for the BT850, the integrator must include specific information in the
user’s guide for the device into which the BT850 is integrated. The integrator must not provide
information to the end user regarding how to install or remove this RF module in the user’s manual of
the device into which the BT850 is integrated. The following FCC statements must be added in their
entirety and without modification into a prominent place in the user’s guide for the device into which
the BT850 is integrated:
IMPORTANT NOTE:
To comply with FCC requirements, the BT850
must not be co-located or
operating in conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna,
If the condition above is met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
