10
www.lairdtech.com
Laird Technologies
CL2510
RF Transceiver
AUTO DESTINATION
Clients can enable Auto Destination to automatically set them in Addressed mode and address themselves
to the Server. This allows the OEM to program all the Clients with an identical configuration, allowing
communication with a central Server. This is valid for both point-to-point and point-to-multipoint networks.
BROADCAST
Enabling Broadcast will set the transceiver to transmit all information as Broadcast Packets.
DESTINATION ADDRESS
When not using Auto Destination or Broadcast, the OEM needs to configure the specific destination address for
addressed packets. This Destination Address is the MAC address of the intended receiving radio.
mAC ADDRESS
The MAC Address is unique 6 byte address assigned at the factory. It is the address a remote radio should place
in the Destination Address field to communicate with that radio.
REmOTE I/O
Remote I/O for CTS/RTS and Remote I/O for DSR/DTR allow these pairs of I/O lines to have their states transmit-
ted across the RF and reflected on the remote radio. These pairs of I/O lines can then be used to transmit state
information or for additional handshaking information. The I/O states are only transmitted a maximum of once
every 13ms, so these lines cannot be used for serial data.
ADDITIONAL FEATURES
The CL2510 is based on Laird Technologies LT2510 Embedded transceiver. Additional features are available
on the CL2510 including advanced API modes and additional AT Commands. For more information on these
features refer to the LT2510 User Manual.
CL2510
CONFIgURATION
SETTINgS
Summary of Contents for ConnexLink CL2510
Page 28: ......
