13
www.lairdtech.com
Laird Technologies
CL2510
RF Transceiver
Auto Archive
When this option is enabled, the application will archive the EEPROM settings for each radio after a
successful write process. Although not required, the application will prompt the user to type a description
of the changes made. Auto Archive can be used to restore the radio to a previously known working
configuration.
Monitor UDP For New Devices
This option is used for legacy ConnexNet products and does not apply to the CL2510.
Status Bar
Located at the bottom of the application window, the status bar gives the state of Port 1, RTS Port 1, CTS
Port 1, Port 2, RTS Port 2, and CTS Port 2 lines. When the text appears black, the current state will be shown.
When the text appears gray, the current state will not be shown. The text shown in the bottom status bar
gives a simplified status of the current, pending software process. The software has no pending process when
“Communications Idle” is shown. On the right side of the status bar a progress bar is maintained to indicate
the progress of longer commands such as a Find Ports or Write Radio.
About Button
The About button can be pressed to determine the revision number of the application and the contact
information for Laird Technologies.
CONFIgURE TAB
The configure tab is used to display the 256 byte EEPROM contents. The screen is able to do this in two formats:
• GUI
• Hexadecimal
The GUI format is the default method of display. The user may change the display by using buttons located in
the lower left corner of the application window. Clicking on the GUI View button will display the data in GUI
format, while clicking on the EEPROM Editor View button will display the data in hexadecimal.
CONFIgURATION
SOFTWARE
OVERVIEW
Summary of Contents for ConnexLink CL2510
Page 28: ......
