Laird MSD45N
Hardware Integration Guide, version 1.1
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
19
Laird Technologies
Americas: +1-800-492-2320 Option 2
Europe: +44-1628-858-940
Hong Kong: +852-2268-6567 x026
As long as the three conditions above are met, further transmitter testing is not required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions cannot be met (for example, certain laptop
configurations or co-location with another transmitter), then the FCC authorization
is no longer considered valid and the FCC ID cannot be used on the final product.
In these circumstances, the OEM integrator is responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna is installed such that 20 cm is
maintained between the antenna and users. The final end product must be labeled in a visible area with the
following: “Contains FCC ID: SQG-MSD45N”.
Manual Information to the End User
The OEM integrator may
NOT
provide information to the end user regarding how to install or remove this RF
module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warnings as show in this Hardware
Integration Guide.
Industry Canada
Note: You must place “Contains IC ID: 3147A-MSD45N” on the host product in such a location that it
can be seen by an operator at the time of purchase.
User’s Guide Requirements (for Model # MSD45N)
RF Radiation Hazard Warning
To ensure compliance with FCC and Industry Canada RF exposure requirements, this device must be installed
in a location where the antennas of the device will have a minimum distance of at least 20 cm from all
persons. Using higher gain antennas and types of antennas not certified for use with this product is not
allowed. The device shall not be co-located with another transmitter.
Installez l'appareil en veillant à conserver une distance d'au moins 20 cm entre les éléments rayonnants et les
personnes. Cet avertissement de sécurité est conforme aux limites d'exposition définies par la norme CNR-
102 at relative aux fréquences radio.
Maximum Antenna Gain – If the integrator configures the device such that the antenna is detectable from
the host product.
This radio transmitter (identify the device by certification number, or model number if Category II) has been
approved by Industry Canada to operate with the antenna types listed below with the maximum permissible
gain and required antenna impedance for each antenna type indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with
this device.
Antenna list refer to
Certified Antennas
.
Le présent émetteur radio (IC: XXXXX-XXXXXXXXX) a été approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise
pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au
gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
