Pinnacle
TM
100 Modem
Hosted Mode Low Power User Guide
https://www.lairdconnect.com/
9
© Copyright 2020 Laird. All Rights Reserved
Americas
: +1-800-492-2320
Europe
: +44-1628-858-940
Hong Kong
: +852 2923 0610
4
LTE
C
AT
-M1
L
OW
P
OWER
O
PERATION
,
R&S
CMW500
4.1
Cat-M1 eDRX
Follow the steps below to configure the Pinnalce
TM
100 modem for low power operation. Figure 6, shows the commands sent.
at+cedrxs=1,4,5
(Note 1& 2)
Toggle DTR to change from HL7800 to nRF radio comm
at+aslp 1
Toggle DTR to change from nRF to HL7800 radio comm
Move M2.59 Jumper from J9 Pin 11 (1.8V) to J9 Pin12 (GND)
Should see CTS Turn from Green to Red On UwTerminalX
Note 1: Per Sierra Wireless recommendations: Use eDRX cycle 81.92 sec, a PTW of 5.12 sec was selected, both parameters
are controlled by the CMW500 setup
Note 2: That same sequence of commands is used to put the modem into PSM, except at+cedrx is replace by at+cpsms.
Note 3: The Current is observed using the Keysight N6705C DC Power Analyzer with ranges set to Auto to get wide dynamic
current range from uA to A.
Figure 7 shows the PTW and eDRX cycle, and Figure 8 shows the Avg Current per hour is 1.064 mA.
Figure 6: Cat-M1 Low Power Mode Command Sequence