SDC-EC15N
Hardware Integration Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
10
© Copyright 2015 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0600
Interface Notes
Pin 11: Although the pin is present, Wake on Wireless is not currently supported in the software.
M
ECHANICAL
S
PECIFICATIONS
Connector Overview
The SDC-EC15N is fully compliant with the PCI Express Card Type 1 mechanical standard. It can be inserted in
any Express Card hardware interface and typically does not require any additional mounting hardware.
RF
L
AYOUT
D
ESIGN
G
UIDELINES
The following is a list of RF layout design guidelines and recommendation when installing a Summit-brand
radio into your device. Please note that because each device is different, Laird cannot approve and/or
guarantee the outcome of your specific design.
Do not run antenna cables directly above or directly below the radio.
Do not place any parts or run any high speed digital lines below the radio.
If there are other radios or transmitters located on the device (such as a Bluetooth radio), place the
devices as far apart from each other as possible.
Ensure that there is the maximum allowable spacing separating the antenna connectors on the radio
from the antenna. In addition, do not place antennas directly above or directly below the radio.
