SDC-EC15N
Hardware Integration Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
14
© Copyright 2015 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0600
When using Laird’s IC grant for the SDC-EC15N, the integrator must include specific information in the user’s
guide for the device into which the SDC-EC15N is integrated. The integrator must not provide information to
the end user regarding how to install or remove this RF module in the user’s manual of the device into which
the SDC-EC15N is integrated. In addition to the required FCC statements outlined above, the following IC
statements must be added in their entirety and without modification into a prominent place in the user’s
guide for the device into which the SDC-EC15N is integrated:
To prevent radio interference to the licensed service, this device is intended to be operated indoors
and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is
installed outdoors is subject to licensing.
The integrator must list out information for each antenna used with the host device into which the
SDC-EC15N is integrated. The following examples are based on the integrated antenna with which the
SDC-EC15N was certified and represent an acceptable format:
Form Factor: Chip Antenna on PCB
Type: Dipole
Maximum 2.4 GHz Gain: 0 dBi
(click for datasheet)
Form Factor: Whip
Type: Dipole
Maximum 2.4 GHz Gain: 2.2 dBi
Tested and Certified 2.4 GHz Transmit Power: 90% of maximum setting
Form Factor: Whip
Type: Dipole
Maximum 2.4 GHz Gain: 1.6 dBi (not used during testing)
Maximum 5 GHz Gain: 5 dBi
Form Factor: Whip
Type: Monopole
Maximum 2.4 GHz Gain: 3 dBi
Maximum 5 GHz Gain: 6.5 dBi
Tested and Certified 2.4 GHz Transmit Power: 95% of maximum setting
Tested and Certified 5 GHz Transmit Power: 100% of maximum setting
European Union
User’s Guide Requirements
The integrator must include specific information in the user’s guide for the device into which the SDC-EC15N
is integrated. In addition to the required FCC and IC statements outlined above, the following R&TTE
statements must be added in their entirety and without modification into a prominent place in the user’s
guide for the device into which the SDC-EC15N is integrated:
