6
No
.
Symptoms
Troubleshooting steps
Process
1
No light at night
Check that the lamp can be manually
activated.
Refer to “Activation and Installation” section
on this user guide and run activation tests.
Check if the solar panel is blocked
from the sunlight by houses, trees and
other obstacles.
Clear obstructions or change installation
location.
Check if there is any artificial light
source(s) shining on the solar panel
during the night.
Remove the artificial light source(s) of
interference or change the installation
location.
Examine status of each component
based on the repair guide.
Replace the damaged component(s).
2
A serious shortage
of working time
Check if the solar panel is blocked
from the sunlight by houses, trees and
other obstacles.
Clear obstructions or change installation
location.
Check if the surface of the solar panel
is dusty or covered.
Clean the surface of solar panels as
detailed above.
Examine if the battery pack is
damaged as per the repair guide
instructions.
Replace damaged battery.
3
Lighting does not
follow the normal
operating mode of
turning on and off
Reprogram.
4
Lights fail to turn
on properly when
humans approach
Check if the air temperature close to
human body temperature.
When the air temperature is close to human
temperature, motion detection may slow
down. It will return to normal after the air
temperature changes.
Check if the installation height is too
high.
It is out of motion detection range when
installation height exceeds 8m. It is
recommended to reduce the height or use
other operating modes.
Replace damaged motion sensor or
controllers.
Troubleshooting:
Activation and installation:
Installation:
Bird spike:
Use 3 self-tapping screws to fix the bird spike along the rim of the top of the light.
(See Figure 1)
1
Figure 1
Install bracket.
Use M8 spring washers, flat washers and M8 screws to connect them, leave
enough space to ensure the bracket can fit onto the pole.
Fit solar light onto pole and make sure it is securely fastened with M8 screws. (See Figure 2).
The maximum torque for those M8 bolts is 14Nm.
Do not surpass this torque specification.
2
3
When the USB is not in use, close it properly with the cap in order to avoid
damaging the controller through dampness or water.
Ø75
~
90mm
The product will be
damaged if the top of the
pole diameter is less
than 75mm.
5
Figure 2
Activation test:
Daytime activation:
after installation.
Night-time activation:
after installation, press and hold the ON/OFF
button to activate by hand.
Functions of ON/OFF button:
1. When the system is switched off, press and hold the button to
activate until the lamp is on;
2. When the system is working normally, press and hold the button for
5 seconds to enter the transportation mode, until the lamp flashes for
three seconds and turn off;
3. When the system is in transportation mode, press and hold the
button for 5 seconds to switch off the system, until the lamp flash for
one second and turn off;
4. When the system is working normally, press the button without
holding to turn the lamp on/off.
ON/OFF button
Switch-off
Switch
-on
Press and
hold for 5S
P
re
s
s a
n
d
h
o
ld f
o
r 5
S
Transportation
mode
P
re
s
s a
n
d h
o
ld
u
n
ti
l l
a
m
p i
s o
n
A licensed electrician is required to install the unit with AC power supply.
Please have a licensed electrician install this unit to avoid risk of shock damage to
luminaries. Pay close attention to the cable polarity. Tie up with waterproof rubberized
fabric after completing wiring.
