Lake Shore Model 321 Autotuning Temperature Controller User’s Manual
Remote Operation
4-5
Table 4-2. Serial Interface Program Control Properties
Current Name
Property
New Value
Label1 Name
Caption
lblExitProgram
Type “exit” to end program.
Label2 Name
Caption
lblCommand
Command
Label3 Name
Caption
lblResponse
Response
Text1 Name
Text
txtCommand
<blank>
Text2 Name
Text
txtResponse
<blank>
Command1 Name
Caption
Default
cmdSend
Send
True
Form1 Name
Caption
frmSerial
Serial Interface Program
Timer1 Enabled
Interval
False
10
12. Add code (provided in Table 4-3).
a. In the Code Editor window, under the Object dropdown list, select (General). Add the
statement: Public gSend as Boolean
b. Double Click on cmdSend. Add code segment under Private Sub cmdSend_Click( )
as shown in Table 4-3.
c. In the Code Editor window, under the Object dropdown list, select Form. Make sure the
Procedure dropdown list is set at Load. The Code window should have written the segment
of code: Private Sub Form_Load( ). Add the code to this subroutine as shown in Table 4-3.
d. Double Click on the Timer control. Add code segment under Private Sub Timer1_Timer()
as shown in Table 4-3.
e. Make adjustments to code if different Com port settings are being used.
13. Save the program.
14. Run the program. The program should resemble the following.
15. Type in a command or query in the Command box as described in Paragraph 4.1.7.3.
16. Press Enter or select the Send button with the mouse to send command.
17. Type Exit and press Enter to quit.
