12
13
•
Shop bought ice cubes tend to be bigger and will take longer to crush and may mean the
sorbet is too soft and needs to be frozen before serving. Homemade ice cubes are often
smaller and quicker to crush.
•
To prevent mixture from melting do not over mix.
•
If the mixture is too soft then it may need to be frozen for a short while before serving.
•
If frozen ensure that it is allowed to rest out of the freezer for a few minutes before serving.
TROUBLESHOOTING
Following are some common problems that can occur when using the blender . Please revue the
problems, their possible cause and any corrective action that should be taken to ensure successful
blending.
Problem
Possible cause
Solution
The unit cannot be switched
on
The blender jug is not locked
into engine base unit
Switch off the blender and
unplug the power cable.
Check the connection
between the blender jug
and base, ensuring the jug is
locked in correctly
The blades do not appear to
be turning
The blade may be jammed
The mixture is too thick to
process
Switch off the blender and
unplug. Carefully remove
ingredients blocking the
blade.
You may need to blend in
smaller batches
My mixture is not blending
evenly
The ingredients you are
processing may be too big
You may be trying to process
a large quantity of ingredients
at the same time
Ensure ingredients are cut
into small enough pieces
before blending
For best results process in
smaller batches
Food is sticking to the side of
the blender
The mixture may be too thick
Switch off the blender and
unplug. Using a plastic
spatula carefully scrape the
food from the wall of the jug.
More liquid may be required
OR you may need to PULSE in
short bursts
CARE AND CLEANING
• Unplug the blender and allow to cool completely before cleaning.
• Before the first use and after every use, clean each part thoroughly.
• Periodically check all parts before reassembly.
• Always use plastic, nylon or silicone spatulas etc. – metal tools will damage non stick coatings.
• Never immerse the unit in water or any other liquid.
• To clean the unit and control panel, wipe with a clean, damp cloth and dry before storing.
• Do not use abrasive cleaners, steel wool or abrasive materials or cleansers.
• Wash the blender jug in hot, soapy water, rinse and dry thoroughly.
• OR you can half fill the jug with warm soapy water. Fit the jug back into the motor base and
with the lid in place let the unit run on speed 2 until the jug is clean
• CAUTION! The blades inside the jug are very sharp. DO NOT touch the blades whilst cleaning.
• Store the blender with the power cable loosely coiled. Never wrap it tightly around the blender
RECYCLING YOUR ELECTRICALS
Along with many other high street retailers, Lakeland has joined a scheme whereby customers can
take their unwanted electrical s to recycling points set up around the country.
Visit
www.recycle-more.co.uk
to find your nearest recycling point.