35
The centre of the loaf is raw, and
not baked enough.
Too much liquid has been used.
There has been a power cut during
the programme cycle.
The ingredient quantities used have
been too large for the maker.
Reduce the liquid by 15ml/3 tsp.
For power cuts lasting more than
10 minutes, you will need to
discard the unbaked ingredients
and start again with fresh
ingredients.
Only use the maximum quantities
recommended for the maker.
The bread does not slice well and
is sticky.
It is being sliced whilst still hot.
The wrong type of knife is being
used.
Let the bread cool for at least 30
minutes to allow steam to escape
before slicing.
Use a good quality bread knife.
Crust colour and thickness
The crust it too dark and too thick.
The DARK crust setting has been
used.
Use the MEDIUM or LIGHT setting
next time.
My loaf is burnt.
The Bread Maker has developed
a fault.
Contact the Lakeland customer care
team on 015394 88100.
The crust is too light.
The bread has not been baked long
enough.
The LIGHT crust setting has been
used.
Carry out a Programme 12 – BAKE
cycle to darken the crust.
Use the DARK or MEDIUM setting
next time.
Bread pan problems
The kneading paddle cannot be
removed from pan.
Add water to the bread pan to
cover the kneading paddle, and
leave it to soak for 10 minutes.
Twist the kneading paddle after
soaking to loosen, and remove.
My bread is stuck to the pan, or is
difficult to shake out.
Loosen the sides of the loaf with
a non stick spatula, knock the
bread pan on a wooden board, or
rotate the base of the paddle stem
underneath the bread pan.
Lightly wipe the inside of the bread
pan with vegetable oil before next
use.
Bread Maker
The Bread Maker is not working,
the kneading paddle is not moving.
The Bread Maker is not switched on
at the socket.
The bread pan not correctly locked
in position.
The timer has been set.
Check the socket is switched on,
and the on/off button has been
pressed.
Check the pan is twisted onto the
bread pan lock correctly.
The Bread Maker will not start until
the start time for the programme
is reached
.