Lakeland 32926, Instruction Booklet

5

1. Timer
2.  Increase button
3.  Set button
4.  Speed setting 
5.  Decrease button
6.  Start/pause button
7.  Power button

LED CONTROL PANEL

1

2

3

4

5

6

7

TO USE THE LED CONTROL PANEL

When the stand mixer is plugged in and switched on at the wall socket the power button 

will softly illuminate on and off to show it is in standby mode.

The LED control panel will only work and if the arm of the stand mixer is in the downward 

position. This is a safety feature.

Press the power button to activate the LED control panel.

CHANGING THE SPEED SETTINGS

•  The speed setting in the middle of the panel will be flashing ‘00’ press either the in 

  crease button ‘+’ to change the speed setting between 1 and 10. 

•  You can decrease by pressing the decrease button ‘-‘.

•  Once you have chosen your desired speed you can press the start/pause button to  

  start the appliance without the timer in operation. 

•  The timer will count up in minutes and seconds ‘mm:ss’.

TO SET THE TIMER FUNCTION

•  Once you have chosen the desired speed, press the SET button and then the timer will  

  flash at the top of the panel. 

•  Press either the increase button ‘+’ to change the timer in minutes and seconds    

  ‘mm:ss’ between 0 seconds and 99 minutes and 59 seconds. You can decrease by  

  pressing the decrease button ‘-‘. 

•  The time will increase in 10 second intervals, press and hold the increase or decrease  

  buttons to move through the time more quickly. 

•  When the timer has counted down and reached 00:00 the appliance will beep three  

 times.

To switch between the Speed and Timer settings press the SET button.

If no buttons are pressed in one minute the control panel will go back into standby mode.