19
3) Die Wandbefestigungen müssen so in die
Dübel geschraubt werden, dass das kleine
Loch an der Unterseite und die Haken nach
oben zeigen.
Montieren Sie die Wandbefestigungen mit den vier Schrauben an der Wand.
WARNHINWEIS: Die Wandbefestigungen müssen in die an der Wand markierte korrekte
Position geschraubt werden. Prüfen Sie die Position durch erneutes Messen des
Abstands zwischen den Markierungen (Maße siehe Abbildung oben).
4) Nehmen Sie nun die Haupteinheit mit den nach oben geklappten beheizten Sprossen zur
Hand. Stecken Sie die beiden Löcher an der Unterseite der seitlichen Sprossen in die beiden
Haken an den Wandbefestigungen.
1024mm
216mm
Das kleine Loch an den Wandbefestigungen
und die Haupteinheit müssten nun aufeinander
ausgerichtet sein.
J18515 DrysoonMountedAirer Ins 7Aug14.indd 19
07/08/2014 15:12